SUPPORT USER GUIDES All General question About firmware Basic Settings APPS Tools User Manual VIDEO REVIEWS

Eversolo Streamers Static IP Configuration Guide

This tutorial applies to A6 and A8,  here we use A6 as an example.

Friendly reminder: When connecting the DMP-A6 to the network cable, if the wired network menu shows that DHCP is on and it has successfully obtained an assigned IP address, you should be able to set a static IP address successfully in most cases.

Operation Guide:

1. Go Settings- Network- Wired Network from the main interface of DMP-A6.

2. Click to disable DHCP, then a network settings menu will pop up, then customize and change the IP address (keeping other configuration options unchanged).


Friendly reminder: From left to right, the first three segments of the IP address remain the same (each person's network environment may have a different segment).

Only modify the last segment: (if the gateway IP ends with 1, you can set any number between 2 and 255 here). Alternatively, you can use the IP address previously assigned through DHCP, ensuring it doesn't conflict with other devices on the local network.

3. [See the image below] After completing the settings, click "OK". When the network status displays "Connected", it indicates that the setup was successful.